Table of Contents
Advertisement
GENERAL PRECAUTIONS COMMON TO OPERA-
TION AND MAINTENANCE
PRECAUTIONS WHEN GETTING ON OR OFF MACHINE
USE HANDRAILS AND STEPS WHEN GETTING ON OR OFF MACHINE
00-A)
To prevent personal injury caused by slipping or falling off the machine, always observe the following.
•
Use the handrails and steps marked by arrows in the figure
on the right when getting on or off the machine.
•
Always face the machine and maintain at least three-point
contact (both feet and one hand, or both hands and one foot)
with the handrails and steps to ensure that you support
yourself.
•
Before getting on and off the machine, check the handrails and steps if there is any oil, grease, or mud on
them. Wipe it off immediately not to slip if any. In addition, tighten any loose bolt of the handrails and steps.
If the handrails and steps are damaged or deformed, they need to be repaired immediately. Ask your Komatsu
distributor to perform this work.
•
Do not grip the control levers when getting on or off the machine.
•
Never climb on the engine hood or covers where there are no non-slip pads.
•
Do not try to get on a tire from the step in the rear side of the machine or the step beside the cab.
•
Do not get on or off the machine while holding tools in your hand.
NO JUMPING ON OR OFF MACHINE
Getting on or off the moving machine can cause serious personal injury. Always observe the following.
•
Never jump on or off the machine. Never get on or off a moving machine.
•
If the machine starts to move when there is no operator on the machine, do not jump on to the machine and
try to stop it.
NO PEOPLE ON ATTACHMENTS
Never let anyone ride on the work equipment or other attachments. There is a hazard of falling and suffering seri-
ous personal injury or death.
2-18
(ALL-0000-17E-K-00-A)
(ALL-0000-17F-K-00-A)
SAFETY
(ALL-0000-001-K-10-A)
(WA470-0000-17D-K-
Advertisement
Table of Contents
