Advertisement
FOREWORD
6.
Flushing operations
After disassembling and assembling the equipment, or changing
the oil, use flushing oil to remove the contaminants, sludge, and
old oil from the hydraulic circuit. Normally, flushing is carried out
twice: primary flushing is carried out with flushing oil, and
secondary flushing is carried out with the specified hydraulic oil.
7.
Cleaning operations
After repairing the hydraulic equipment (pump, control valve, etc.)
or when running the machine, carry out oil cleaning to remove the
sludge or contaminants in the hydraulic oil circuit. The oil cleaning
equipment is used to remove the ultra fine (about 3 µ) particles that
the filter, built in the hydraulic equipment, cannot remove; it is an
extremely effective device.
Handling Connectors Used for Engines
The following engines use the connectors described in this section.
•
95E-5
•
107E-1
•
114E-3
•
125E-5
•
140E-5
•
170E-5
•
12V140E-3
★ Your machine has a 107-E engine.
Slide Lock Type
FRAMATOME-3, FRAMATOME-2
★ 95 – 170, 12V140 engines
•
Pressure sensors and NE speed sensor
Engine
125, 170, 12V140
125, 170, 12V140
95, 107, 114
95 – 170, 12V140
125, 170, 12V140
00-20
c
HANDLING ELECTRIC AND HYDRAULIC EQUIPMENT
Sensor
Intake air pressure sensor in intake manifold: PIM
Oil pressure sensor: POIL
Oil pressure switch
Ne speed sensor of flywheel housing: NE
Ambient pressure sensor: PAMB
00
00
WA250-6
Advertisement
