LG LP076HD3A Service Manual page 26

Table of Contents

7. Remove the screw that attaches the electric heater wire to

the side of the indoor fan housing.

8. Remove the 3 screws which fasten the top cover assembly.

�

Figure 26

�

9. Position water spraying plastic tube into the electric heater

cover. Make sure that the three pairs(total of six) of plastic

tongues snap into the corresponding metal slots of the

heater frame as shown in Figure 27. Then install one of the

three rubber elbows(ref. Figure 31.) at the inlet of the

spraying tube and through the rubber grommet.

�

Figure 27

�

10. Place the top cover assembly back into the unit.

Only for training and service purposes

11. Install tube #1 and tube #2 (ref. Figure 31.) on the pump

assembly using the rubber elbows as shown in Figure 28.

�

Figure 28

�

12. Position pump assembly to the basepan as shown in

Figure 29. and fasten the pump bracket to the basepan

using the three screws provided.

�

Figure 29

�

13. Insert tube #2 of the pump assembly through the plastic

grommet of the sheet metal partition as shown in Figure 30.

Then connect the end of tube #2 to the plastic elbow

coming out of the inlet of the spraying tube.

Figure 30

- 26 -

LGE Internal Use Only

Table of Contents