Zanussi ZI 9220 FF Installation Manual page 11

Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
CONTENTS
Warnings
Use
Cleaning the interior
Control panel
Display
Operation
Activation of function
Switching off
Temperature regulation
Freezing fresh food
Storage of frozen food
Excessive temperature alarm
Door open acoustic alarm
Thawing
Ice-cube production
Cold accumulator
14
All manuals and user guides at all-guides.com
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recyclable.
13
Hints
15
Hints for freezing
Hints for storage of frozen food
15
Maintenance
15
15
Periodic cleaning
16
Periods of no operation
16
Defrosting
16
Customer service and spare parts
16
Technical information
16
16
Installation
17
Location
17
Electrical connection
17
17 Door Reversibility
Instruction for totally built-in appliances
17
Fijar el aparato con los 4 tornillos en dotación.
(I = 3,5 x 13) e (P = 3,5 x 22) .
Colocar a presión el cubrejuntas entre el aparato y
el mueble.
Colocar les tapas (C-D) sobre los extremos del perfil
y en los agujeros para la bisagra.
Colocar la parrilla de aireación (B) encajándola a
presión y engornar la tapa (E) en posición.
Separar las piezas Ha, Hb, Hc, Hd según se indica
en la figura.
18
18
18
19
19
19
19
19
Apoyar la guía (Ha) sobre la parte interior de la
19
puerta del mueble arriba y abajo según se indica en
la figura y marcar la posición de los agujeros
20
exteriores. Una vez que se hayan hecho los
20
agujeros, fijar la guía con los tornillos presentes en
el equipo base.
20
20
21
I
P
D724
C
D
E
B
Hb
Ha
Hc
Hd
PR266
ca. 50 mm
90°
90°
ca. 50 mm
11