Advertisement
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems, which
are being done at the customers expense,
may be performed by any non-road engine
repair establishment or individual. Warranty
repairs must be performed by an authorized
engine manufacturer's service outlet.
TO ADJUSTTHROTTLE
CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
1. With engine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
2. Check that holes "A" in governor
control lever and hole in governor plate
line-up. If holes "A" are not aligned,
loosen clamp screw and move throttle
cable until holes are aligned. Tighten
clamp screw securely.
Governor Control Lever
Governor Control Plate
Holes
"A"
Clamp Screw
Cable
TO ADJUST CARBURETOR
NOTE: The carburetor on this engine is
low emission.
It is equipped with an idle
fuel adjusting needle with a limiter cap,
which allows some adjustment within the
limits allowed by the cap. Do not attempt
to remove the limiter cap. The limiter cap
cannot be removed without breaking the
adjusting needle.
The carburetor has been preset at the
factory and adjustment should not be
necessary.
However, minor adjustment
may be required to compensate
for differ-
ences in fuel, temperature,
altitude or load.
If the carburetor does need adjustment,
proceed as follows:
In general, turning idle mixture valve in
(clockwise) decreases the supply of fuel to
the engine giving a leaner fuel/air mix-
ture. Turning the idle mixture valve out
(counterclockwise)
increases the supply
of fuel to the engine giving a richer fuel/air
mixture.
IMPORTANT:
Damage
to the needle
valve and the seat in carburetor
may result
if screw
is turned
in too tight.
PRELIMINARY
SETTING -
1. Air cleaner assembly must be assem-
bled to the carburetor when making
carburetor adjustments.
2. Be sure the throttle control cable is
adjusted properly (see above).
FINAL SETTING -(See "TO ADJUST
THROTTLE CONTROL CABLE" in this
section of the manual.)
1. Start engine and allow to warm for five
minutes.
Make final adjustments
with
engine running and shift/motion control
lever in neutral (N) position.
2. Move throttle control lever to slow posi-
tion. With finger, rotate and hold throttle
lever against idle speed screw. Turn
idle speed screw to attain 1750 RPM.
3. While still holding throttle lever against
idle speed screw, turn idle mixture
valve full travel clockwise then coun-
terclockwise
until engine runs rough.
Turn valve to a point midway between
those two positions.
Release throttle
lever.
ACCELERATION
TEST
-
4. Move throttle control lever from slow
to fast position.
If engine hesitates or
dies, turn idle mixture valve out (coun-
terclockwise)
1/8 turn. Repeat test and
continue to adjust, if necessary, until
engine accelerates
smoothly.
High speed stop is factory adjusted.
Do
not adjust or damage may result.
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeed-
ing the engine above the factory high
speed setting can be dangerous. If you
think the engine-governed
high speed
needs adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Idle Speed
Lever
Idle Mixture
Valve with
Limiter
28
Advertisement
