Blaupunkt WM40U Owner's Manual page 5

1. Never use the device unsupervised! Switch off the device whenever
you are not using it, even if this only for a short while.
2. The appliance is not intended to be operated by means of an
external timer or separate remote control system.
3. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
4. Before operating this system, check the voltage of this system to see
if it is identical to the voltage of your local power supply.
5. To prevent fire or shock hazard, do not expose this equipment to hot
places, rain, moisture or dust.
6. Do not place this unit close to a strong magnetic field.
7. Do not place the unit on a amplifier or receiver.
8. Do not place this unit in a damp area as the moisture will affect the
life of electric components.
9. If the system is brought directly from a cold to a warm location, or is
placed in a very damp room, moisture may condense on the lens inside
the player. If this occurs, the system will not operate properly. Please
leave the system turned on for about an hour until the moisture
evaporates.
10. Do not attempt to clean the unit with chemical solvents as this
might damage the finish. Wipe with a clean, dry or slightly damp cloth.
NOTICE
Conformity
Hereby, Blaupunkt Competence Center 2N-Everpol Sp. z o.o., declares
that this equipment is in compliance with the essential requirement
and other relevant provisions of Directive 2014/53/EU. Declaration of
conformity can be obtained from the product page at
www.blaupunkt.com.
Responsible party: 2N-Everpol Sp. z o.o, Puławska 403A, 02-801
Warsaw, Poland, Phone: +48 22 688 08 00, E-mail:
Your products is designed a manufactured with high quality materials
and components, which can be recycled and reused.
3
info@everpol.pl