Noise Emission And Vibration; Responsibilities Of The Operator - Palax C750.2 Instruction Manual

The width of the machine equipped with the 4,3-m conveyor is about 2.83 m. This

means that, depending on the size of the tractor, the transport width of the conveyor
may extend outside the rear wheel on the right-hand side.
The operator
Every person operating the machine, must thoroughly study the entire user manual.

Always use eye guards and hearing protectors.

Always wear protective shoes.

Always wear work gloves.

Do not wear loosely-fitting clothing.

Before use
Always carry out the required preparations on both the machine and the conveyor

before starting the operation.
Make sure that all other people stay outside the operating range.

Only use a fault-free PTO shaft and attach the chain for the shaft-guard. The

permissible revolutions range of the PTO shaft is 450-540 r.p.m.
Only operate the machine on a sufficiently firm and level surface.

Only operate the machine in an adequately lit space.

Keep the tractor-powered machine connected to the three-point linkage. Also ensure

that sufficient space is provided for the PTO shaft and its guard.
Always check that all the covers are intact and properly fastened.

Always check that the crosscut saw-bar is intact.

Always ensure that the electric conductors are intact.

Always check that all the controls are operational.

Always check the oil level and make sure that the hydraulic hoses and components are

free of damage.
Before starting the work, make sure that the machine is firmly in position.

During operation
Carelessness during the cut-off operation constitutes a major hazard!

During the cut-off operation, make sure that the tree at the cutting point always leans

against the support roller of the crosscut deck and the infeed roller: danger of rolling
over!
Exercise particular caution when cutting knotty or crooked logs, because, as a result of

faulty cutting, the log might roll over or twist the saw-bar with enough force to break it.
Keep the working space clean and clear of foreign objects.

Always stop the machine and disconnect the power supply cable or the power take-off

shaft before servicing.
Only cut one log at a time.

Danger! Stay away from moving parts.


Noise emission and vibration

1.8
Equivalent continuous A-weighted sound-pressure level at the workstation is 88.5 dB (A)
and the sound power level is 108.5 dB (A). The vibration emission values do not exceed
2.5 m/s2.
1.9

Responsibilities of the operator

The machine may only be used to produce firewood.

Palax C750.2 Translation
10
1-2020