Advertisement
GTX
®
Pedestrian 12" Pixelated Overlay Signal Modules
Installation Steps
Verify input voltage is within specified range on the back of the LED signal module before installation.
1
Failure to do so will cause lamp to fail.
Open front cover of (customer supplied) traffic signal housing.
2
Connect the wires to the appropriate terminal block within customer supplied signal housing.
3
Red wire ➔ ( + for Hand ),
Brown wire ➔ ( + for Person ),
White wire ➔ ( for the neutral ).
Close front cover of (customer supplied) traffic signal housing ensuring that the module gasket is tight
4
within the housing.
Voltage Rating
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram
are trademarks of the General Electric Company and are used under license.
Information and specifications subject to change without notice. All values are design
or typical values when measured under laboratory conditions.
CAUTION
RISK OF ELECTRIC SHOCK
Install unit in enclosure
tested to be suitable for wet
locations only.
TRAF048-Pedestrian-12-inch-Pixelated-Overlay-Signal-Modules-lnstallation-Guide
Installation Guide
Page 2 of 2
(Rev 06/21/23)
Advertisement
