Maintenance - Schneider Airsystems CPM 170-8-2 WOF Original Operating Manual

GB
CPM 170-8-2 W-oilfree
Table of contents - Part 1
1.1 Scope of delivery ......................
1.2 Conventional use ......................
1.3 Technical data ..........................
1.4 Components.............................
1.5 Adjusting the working pressure...
1.6

Maintenance.............................

1.7 Vessel inspections .....................
1.1 Scope of delivery
– Compressor with instruction manual
1.2 Conventional use
The compressor is designed for generating
and storing compressed air only. Com-
pressed air is only suitable for compressed
air tools/devices/machines.
Any other type of use is considered contrary
to the intended use.
The compressor must not be used in poten-
tially explosive areas. Combustible, caustic
or toxic gases must not be sucked in!
1.3 Technical data
see Fig. 1a
1.4 Components
01 Compressor unit
02 Intake filter
07 Check valve
08 Vessel
09 Condensate drain valve
10 Pressure switch with ON/OFF switch
11 Safety valve
I/2
12 Pressure gauge (vessel pressure)
13 Pressure gauge (working pressure)
2
14 Electric motor
2
18 Pressure reducer
2
19 Quick-action coupling (clean, regu-
lated compressed air)
2
2
1.5 Adjusting the working pres-
sure
2
Rotate clockwise = pressure is increased.
2
Rotate anticlockwise = pressure is reduced.
1.6 Maintenance
1.6.1 Cleaning the intake filter
1. Loosen the screws and open the housing
as shown in Fig. 5a.
2. Pull out the filter insert. (Fig. 5a)
3. Clean the filter insert using the blow gun,
exchange the filter insert if necessary.
4. Insert the filter insert.
5. Close the housing and tighten the
screws.
1.7 Vessel inspections
No inspections are specified for the ves-
sels.
We recommend that a "qualified person"
perform a pressure test on the vessel, de-
pending on its rate of utilisation, after 10
years in accordance with the Ordinance on
Industrial Safety and Health. Contact any of
our service partners.
The statutory specified inspections must
be arranged in accordance with the appli-
cable regulations of the respective coun-
try in which the vessel is used.