Table of Contents
Advertisement
INVERTER ARC 230
INSTALLATION
TIG WELdING (GTAW)
This machine does not have a built in Gas Solenoid so a one piece
gas valve TIG Torch is required. A K960-1 Twist-mate TIG Torch
adapter is also required. Refer to the accessories section for more
information about TIG Torches and required Twist-mate adapter.
Most TIG welding is done with DC(-) polarity shown here. If DC(+)
polarity is necessary switch the cable connections at the machine.
(See Figure A.2)
Connect the torch cable to the (-) terminal of the machine and the
work clamp to the (+) terminal. Insert the connector with the key
lining up with the keyway and rotate approximately 1/4 turn
clockwise. Do not over tighten. Finally, connect the Twist-mate
adapter gas hose to the gas regulator on the cylinder of gas to be
FIGURE A.2
used.
Positive "+"
Work Cable
Negative "–"
K960-1
Gas Valve to TIG Torch
Work Clamp
A-3
Advertisement
Table of Contents
