Shutting Off The Engine; Recycling The Clippings - Toro Recycler 20337HD Operator's Manual

22in
Hide thumbs Also See for Recycler 20337HD:
Table of Contents

Advertisement

g233423
Figure 14
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
12). If the
side-discharge chute is on the machine, remove it;
refer to
Installing the Side-Discharge Chute (page
13).
11

Advertisement

Table of Contents
loading

Table of Contents