Advertisement
SA-22015T, SA-22030T, SA-22050T
Read this manual before use
This hook was used for hang,
not to lock tightly.
To loose the two
screw and tighttn, to
adjust the wire
Operation Manual
A sling, suspend
the tool here.
Always attached a
secondary support
cable or chain.
Turn CW.(
)
For decreasing about 1.0cm
(Keep the allen key and turn
slowly, even don't adjust
under its capacity)
SA-22015T(22030T)(22050T)-I-2209C-YM
1
Turn CW. (
)
For increasing the
spring tension by
allen key.
Advertisement
Table of Contents
Related Manuals for Sumake SA-22015T
Summary of Contents for Sumake SA-22015T
- Page 1 Operation Manual SA-22015T, SA-22030T, SA-22050T Read this manual before use Always attached a secondary support This hook was used for hang, cable or chain. not to lock tightly. Turn CW. ( For increasing the spring tension by allen key. To loose the two...
- Page 2 Prohibition Caution Incorrect use of the spring balancer could cause personal injury. Observe instruction in the manual and use the balancer correctly. Never stand under the spring balancer. Prohibition of disassembly. Never put the spring balancer in fluid.
- Page 3 Don’t twist and rub the cordage with cable during travel. Don’t load over its capacity. 1. Take the tools off while remove the spring balancer, prevent the devise drop down. 2. Please remove the spring balancer and tools if rest for a long time. 3.
- Page 4 Leave some slack in the secondary support cable or chain to allow the balancer to rotate freely. The slack must be a suitable length so that the balancer will stop within 10cm when falling in case of failure of the hanger or the fitting.
- Page 5 Model Capacity Weight Travel SA-22015T 0.5 – 1.5 kg 1.8 kg 1.4 m SA-22030T 1.5 – 3.0 kg 1.9 kg 1.4 m SA-22050T 3.0 – 5.0 kg 2.1 kg 1.4 m 1. Installation (1) Attached the spring balancer to the steady place.
- Page 6 DECLARATION OF CONFORMITY SUMAKE INDUSTRIAL CO., LTD. 4F, No. 351, Yangguang St., Neihu District, Taipei City, Taiwan declare in sole responsibility that the equipment Equipment： AIR PU HOSE BALANCER Model/ Serial No.： SA-22015T(22030T)(22050T) to which this declaration applies, complies with these normative documents: ...
- Page 7 SA-22015T AIR PU HOSE BALANCER (0.5-1.5KG) SA-22030T AIR PU HOSE BALANCER (1.5-3.0KG) SA-22050T AIR PU HOSE BALANCER (3-5KG) PARTS LIST Parts No. Description Q'ty SA22030T-01 Spindle SA22030T-02 Screw SA22030T-03 Ratchet SA22030T-04 Ratchet Spring 6~-12 SA22030T-11S Casing Set [Incl. 6, 7, 8, 9, 10, 11, 12] Spring Plate Set [Incl.
- Page 8 NOTE www.SUMAKE.com www.aircompressors.com.tw...
Need help?
Do you have a question about the SA-22015T and is the answer not in the manual?
Questions and answers