Advertisement
Read this manual before use
Do not fasten the hanger
When the spring
breaks, the sage pin
pops out from the
spring case and
collides with one of
the pins, to stop the
drum rotating.
Bottom hook
Operation Manual
SA-22220, SA-22300
Always attached a
secondary support
cable or chain.
Turn CW.(
For increasing the
spring.
Turn CCW.(
For increasing the
spring.
SA-22220(22300)-I-2206C-YM
1
Don't adjust of the
maintains device.
)
)
Advertisement
Table of Contents
Related Manuals for Sumake SA-22220
Summary of Contents for Sumake SA-22220
- Page 1 Operation Manual SA-22220, SA-22300 Read this manual before use Do not fasten the hanger Always attached a secondary support cable or chain. When the spring breaks, the sage pin Don’t adjust of the pops out from the maintains device. spring case and...
- Page 2 Prohibition Caution Incorrect use of the spring balancer could cause personal injury. Observe instruction in the manual and use the balancer correctly. Never stand under the spring balancer. Prohibition of disassembly. Never put the spring balancer in fluid.
- Page 3 Don’t twist and rub the cordage with cable during travel. Don’t load over its capacity. 1. Take the tools off while remove the spring balancer, prevent the devise drop down. 2. Please remove the spring balancer and tools if rest for a long time. 3.
- Page 4 Leave some slack in the secondary support cable or chain to allow the balancer to rotate freely. The slack must be a suitable length so that the balancer will stop within 10cm when falling in case of failure of the hanger or the fitting.
- Page 5 (1) The hanger and bottom hook is steady and turn swivel. (2) The cable is complete. (3) The Brake Pin is in the being position. (4) The appearance is complete, no any damage. Item no. Capacity Length Wieght SA-22220 15~22kg 1.3m 7.09kg SA-22300 22~30kg 1.3m 7.59kg...
- Page 6 DECLARATION OF CONFORMITY SUMAKE INDUSTRIAL CO., LTD. 4F, No. 351, Yangguang St., Neihu District, Taipei City, Taiwan declare in sole responsibility that the equipment Equipment： SPRING BALANCER Model/ Serial No.： SA-22220(22300) to which this declaration applies, complies with these normative documents: ...
- Page 7 Worm Gear SA22220-32 Type E Snap SA22220-04 Spindle SA22220-41 Washer SA22220-05 Drum 51A SA22220-51A Bearing Spring Set [SA-22220] 52A SA22220-52A Screw SA22220-06S (Incl. 6, 7, 11, 12, 72, 75) SA22220-61 Spindle Sleeve Spring Set [SA-22300] SA22220-71 Spring Cover SA22300-06S (Incl. 6, 7, 11, 12, 72, 75)
- Page 8 NOTE...
Need help?
Do you have a question about the SA-22220 and is the answer not in the manual?
Questions and answers