Adjusting The Cutting Height - Toro TimeMaster 21199 Operator's Manual

Adjusting the Cutting Height

DANGER
Adjusting the cutting-height levers could bring your hands into contact with a moving blade
and result in serious injury.
• Shut off the engine, remove the ignition key (if equipped), and wait for all moving parts to
stop before adjusting the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be hot and can burn you.
Keep away from the hot muffler.
Note:
To raise the machine, move the front and rear cutting-height levers forward; to lower the machine,
move the cutting-height levers rearward. Set all the wheels to the same height unless special circumstances
require otherwise.
Figure 13
12
g224172