Advertisement
13.
Install the FML Port Extension 25 (#2121) on the FML Dome Port A6 (#2111) as described in the port
extension instruction manual.
14.
Mount the port extension and dome port on the housing as described in the housing instruction manual.
15.
Prior to closing the housing, test the housing Lens Dial again. If required, reposition the Lens Gear on the
lens as described in step 10 above.
16.
Close, seal and lock the housing as described in the housing instruction manual.
CARE & MAINTENANCE
1.
Please use the utmost care and do not use excessive force when assembling and disassembling the different
parts, in order not cause any damage to the products.
2.
During installation, removal, storage and transportation, take special care not to damage the spongy shading
pad featured on the Lens Gear.
3.
Keep the Lens Gear away from extreme high temperatures, as under direct sunlight, since it might damage
the product.
4.
Do not clean the Lens Gear with any chemical solvents or other materials, which might cause damage to the
product.
5.
When storing the Lens Gear and during transportation, make sure that it is properly protected in order to
prevent deformation of the product.
6.
Do not store the Lens Gear in presence of chemicals, solvents or fuels.
3
SEL1018 Lens Gear Instruction Manual 20170620
Fig.8
Advertisement
