Summary of Contents for Fantasea Line Lens Gear SEL1018
Page 1
Lens Gear Spacer ASSEMBLY INSTRUCTIONS The Lens Gear SEL1018 should be installed on the Sony SEL1018 lens prior to mounting the lens on the camera. Remove the rear cap of the lens. Hold the Lens Gear facing the rear side of the lens so that the gear teeth are pointed away from the lens (Fig.1).
Page 2
Hold the Spacer facing the rear side of the lens so that the gap on the Spacer is aligned with the white dot on the lens mount (Fig.3) Install the Spacer by sliding it from the back of the lens towards its front, so it enters the gap between the Lens Gear and the lens (Fig.4).
Page 3
Fig.8 Install the FML Port Extension 25 (#2121) on the FML Dome Port A6 (#2111) as described in the port extension instruction manual. Mount the port extension and dome port on the housing as described in the housing instruction manual. Prior to closing the housing, test the housing Lens Dial again.
Page 4
FANTASEA PRODUCT CONSUMER LIMITED WARRANTY “Fantasea” warrants this Fantasea Line branded product against defects in materials and workmanship under reasonable use for a period of ONE (1) YEAR, (two years, where required by law as determined by the origin of the authorized dealer).