Schedule For User's Program; Parameters And Functions - LK SmartComfort RT Manual

ENG | Instruction Manual

SCHEDULE FOR USER'S PROGRAM

: :
: :
: :
: :
: :
: :
: :
: :
: :
6
March
15
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
° C 1 2 3 4 5 6 7
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
° C 1 2 3 4 5 6 7
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
1 2 3 4 5 6 7
° C
° F
www.lkarmatur.com
No

Parameters and Functions

10
bEd: (+) or (-) to set the desired temperature for
programs P1-P9
11
Out: (+) or (-) to set the desired temperature for
programs P1-P9
12
InP: (+) or (-) to set the desired temperature for
remote operation .
Diagnostic function:
closed contact.
20 deG: Temperature units - °C Celsius or °F Fahrenheit
21 Time format 24H (24:00) or 12H (12:00 AM/PM)
22 dSt: Summer time change.
manual change of time. Date is not used.
30 AirC: Calibration of the room temperature display
±5°C/±8.5°F. The calibration should be done after 1 day's op-
erating with the same set temperature. Place a thermo-me-
ter close to the controller and check the temperature in the
room after 1 hour. When you enter the calibration parameter,
no is displayed to indicate that no calibration has been made.
To enter the value shown on the thermo-meter, use (+) and
(-) keys to enter the real value. Then press
message YES is displayed and the value will be stored in the
internal memory. You can cancel the calibration by pressing
OK and then .
31 OutC: Calibration of outdoor temperature sensor
±10°C/±17°F. The same calibration procedure described for
30 AirC, except for the location of the thermometer.
40 LANG Fr/EN: Change of language. Use (+) or (–) keys to
select French or English.
80 Clr ALL: Resetting to factory settings.
Note: Ensure that you have all necessary information to reset
your installation before using this function.
Press and hold the
pera-tures and parameters in this menu to factory settings.
User programs will also be reset.
90 Software version
99 End: Press the OK
normal operation.
Reservations for product improvements.
The frame around the symbol shows
YES automatic change.
OK to confirm. The
OK key for 10 seconds to reset tem-
key to exit parameter menu and return to
in
in
during
no