Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FCI SmartFlush ATF-0001
Summary of Contents for FCI SmartFlush ATF-0001
- Page 1 SmartFlush In-Wall Automatic Toilet Flusher ATF-0001 Installation Manual Quality Guarantee *Thank you for choosing the automatic urinal flusher. Please read the instruction carefully before installation. This manual is for your reference only. P a g e...
-
Page 2: Specifications
Features • Hands free sensor operation. • Adjustable control stop for water flow adjustment • Manual push button for flushing. • Adjustable sensing distance Specifications Power 6V (4 x Alkaline AC 110-240V 50 – 60 Hz 0.3 – 0.8 MPa Water Pressure 0.1 –... - Page 3 Construction / Installation Diagram Plumbing installation must be in accordance with applicable codes and regulations. Water supply lines must be sized to provide an adequate volume of water for each fixture. Flush all waterlines prior to operation. Prior to installing your Flush Valve, install the items listed below: •...
- Page 4 where sensor faces a mirror, stainless steel wall, other highly reflective surfaces or another infrared sensor. Determine the installation location of the studs and water supply pipe relative to the position of the toilet. P a g e...
- Page 5 Detection / Activation No manual adjustments are required for most settings. Default beam’s effective range is 65 – 70 The factory setting should be satisfactory for most installations. Water Flow Time Adjustment Default water flow delivery is 8 seconds. 1. Press te black push button 5 times (x5) unit the red LED stays on.
-
Page 6: Range Adjustment
Range Adjustment If the range is too short or too long, it can be adjusted. 1. Using a phillips screw driver remove the stainless steel cover plate by unscrewing the screw from the bottom of the plate. 2. Ensure both cables are connected. 3. - Page 7 Solenoid Valve Maintenance 1. Shutfoff all water lines. 2. Remove the stainless steel front cover. 3. Disconnect the sensor & power cables. 4. Using a phillips screw driver remove the black plastic front cover. 5. Remove the four solenoid valve screws (black body).
-
Page 8: Flow Rate Adjustment
Flow Rate Adjustment Locate the control stop (stop valve) & with a flat head screw driver adjust (counter clockwise) the stop valve to desired flow rate. Battery Replacement Replace battery when RED LED indicator flashes rapidly or when flusher stops functioning. i. - Page 9 Troubleshooting Valve does not flush. The main valve in water supply line or the control stop is shut off. Open the main valve or the stop valve. ii. The connectors are not connected. Connect the wires. iii. The surface of the sensor is dirty. Clean surface with soft cloth.
-
Page 10: Care And Cleaning
Care & Cleaning IMPORTANT! Do not scratch the sensor or faceplate when cleaning. Avoid using any cleaning materials that may scratch the surface. Never use polishing powder, detergent that includes coarse particles, thinners, benzene, acids, alkaline detergents, or nylon scrub brushes. To safely clean the surface, wipe it using a dampened soft cloth with diluted dishwashing detergent and dry it with another soft cloth. -
Page 11: Warranty Information
Resources For Installation guides, visit our resource page through the QR code Alternatively, you can visit our resource page at https://faucetscanada.ca/resources/ To view more products from Faucets Canada, visit our shop page through the QR code. Alternatively, you can visit our shop page at https://faucetscanada.ca/shop/ Warranty Information... - Page 12 About us Here at FCi, our main goal is to break the eco- innovation boundary and provide customers with fixtures that save water and deliver reliable sources of sanitation every time. As Canada’s favourite automatic faucet brand, we are proud to say we deliver quality touchless fixtures that perform beyond expectations and exceed design standards.