Page 1
B16-BMB1 MOTHERSHIP BMB1 Rev C Rom 2 Quick Start Guide Revision 1.7 April 30, 2018...
Page 2
B16-BMB1 1. GETTING STARTED 1.1 Register Please register all serial numbers for your B16 MOTHERSHIP chassis, all Daughter Cards, and BP-300 power supply. You must register to activate your warranty! Please visit: www.burlaudio.com/register. 1.2 Check Jumper Settings On BMB1 The B16 MOTHERSHIP is fully modular, accommodating a wide variety of I/O needs. Jumper settings on the BMB1 Motherboard allow for different I/O routing possibilities.
Page 3
B16-BMB1 EXAMPLE A: JUMPERS ON 1 AND 3 (FACTORY SETTING) BMB1 jumper settings for a 40 in x 40 out system using BAD8 and BDA8 Daughter Cards Image 3: Jumpers on 1 and 3 for BMB1 Rev C Rom 2 support BAD8 and BDA8.
Page 4
B16-BMB1 EXAMPLE C: JUMPERS ON 2 AND 3 BMB1 jumper settings for a 32 in x 32 out system using BAD8, BDA8, BAES4 and BCLK Daughter Cards Image 7: Jumpers on 2 and 3 support BMB1 Rev C Rom 2 BAD4’s, BAD8’s BAES4, and Image 6: This is an example of a 32 in x 32 out BCLK Daughter Cards.
Page 5
B16-BMB1 CHANNEL MAPPING FOR JUMPER SETTINGS JUMPERS 1 AND 2: INPUTS iii. CHANNEL MAPPING FOR JUMPER SETTINGS JUMPERS 3 AND 4: OUTPUTS iii. 1.3 Install Daughter Cards Image 10: Insert the Daughter Card into the card Image 11: Attach the ribbon cable guides.
Page 6
B16-BMB1 1.4 Install Vents Image 12: B16 MOTHERSHIP with 1U vent above for proper airflow. Important Installation Notes: Install the 1U vents above the B16 chassis. The MOTHERSHIP MUST run with proper ventilation. Failure to properly vent the MOTHERSHIP chassis above and below may cause failure, and will void the warranty.
Page 7
B16-BMB1 1.7 Input Assignments Image 13: B16 input assignment in Pro Tools IO settings. B16 Ch. 1-16 are HDIO#1 Ch. 1-16 B16 Ch. 33-48 are HDIO#3 Ch. 1-16 B16 Ch. 17-32 are HDIO#2 Ch. 1-16 B16 Ch. 49-64 are HDIO#4 Ch. 1-16 1.8 Output Assignments Image 14: B16 output assignment in Pro Tools IO settings.
Need help?
Do you have a question about the B16-BMB1 MOTHERSHIP and is the answer not in the manual?
Questions and answers