Display Operation Manual; Pressure Adjustment - Profi-pumpe INVERT-TECH 6 10 Series Operating Instructions Manual

4 English

6. DISPLAY OPERATION MANUAL

7 7
0 0
1 1
2 2
NO. Display panel - description
0 On / Off button
1 Lock protection indicator light
2 Over temperature protection indicator light
3 Water shortage protection indicator light
4 Abnormal voltage indicator light
5 Button to Iower the pressure
6 Button to Increase to pressure
7 Display screen
(See page 14, point 12 for light indicator / error code)

7. PRESSURE ADJUSTMENT

1. Press or ; the display screen
Then press or continuously to add or reduce pressure.
2. After adjusting to required pressure, release the button for 5 seconds to exit the pressure setting mode.
3. Check the recommended pressure for your pump, which you can set before using the pump.
(This can be set as required)
Standard pressure setting:
Invert-Tech 6-400-10: 2,5 bar (25 m)
Invert-Tech 6-600-10: 2,8 bar (28 m)
Invert-Tech 6-800-10: 3,2 bar (32 m)
Display panel
3 3
will switch to pressure setting mode and the numbers start blinking.
Please set pump
pressure according
to your demand.
6 6
Pump will not start, if static
water pressure is higher
than starting pressure
value. Pump does not stop
if the set value is higher
than the max. pump
5 5
pressure.
4 4