M.2 Solid-State Drive - Lenovo DA-07s35V User Manual

9. Pivot down the storage drive and the bracket, and then secure the screw.
10. Connect the signal cable and the power cable to the new storage drive and bracket.
11. Reinstall all removed parts.
12. Place the computer in an upright position.
13. Reconnect the power cord and all disconnected cables to the computer.

M.2 solid-state drive

Prerequisite
Before you start, read Appendix A "Important safety information" on page 45 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 28.
2. Remove the front bezel. See "Front bezel" on page 32.
3. Remove the optical drive. See "Optical drive" on page 33.
4. Remove the storage drive bracket. See "Storage drive" on page 35.
.
Chapter 7 CRU replacement
37