Philips HTS6600/05/12 Service Manual page 20

EN 20 4. 3139 785 32530
4.1.3 Dismantling of the Front White LED, Front Display, Front
Key and IR Boards
1) To dismantle the boards of the Front Panel 1010, it is
necessary to remove the SD9.2 MPEG board1070. The
Front White LED board 1017 should be detached fi rst by
unscrewing the mounting screw. Then remove 3 mounting
screws to dismantle the Front Display board 1012 (One
screw is hidden underneath the FFC Foil 8010).
2) Remove 4 screws to dismantle the Front Key board 1013.
3) Only one screw should be removed to dismantle the IR
board 1018. The mounting screws for boards of the Front
Panel 1010 are shown in fi gure 11.
J
J
Figure 4-11
4.1.4 Dismantling of the DVD mechanism
1) To dismantle the DVD mechanism 1080, the FFC
dressing board should be removed fi rst by removing 2
mounting screws.
2) Then remove 4 screws and dismantle the DVD
mechanism as shown in fi gure 12. (Refer to "Service
Hints" in chapter 2 for replacing the DVD mechanism.)
Figure 4-12
Dismantling Instructions & Service Positions
J
IR Board
J
Front Display Board
White LED
Front Key Board
K
4.1.5 Dismantling of the Motor Assembly, Door open and Door
Close Boards
1) The Door Open 1015 and Door Close 1016 boards are
attached to the Rack-1 (117) without any mounting screw.
Detaching them can be done readily.
2) To dismantle the Motor Assembly (126+130+127+128+
129+125), remove 3 screws as shown in fi gure 12.
Board
L
Figure 4-13