Sureguard Pro-Tech 5 User Instructions page 11

❖ Touch 4 times (Function #4):
Timer is switched onto
minutes after sunrise. At night the Energiser is in standby mode, and the FENCE LED
glows BLUE. NOTE: The Alarm Buzzer may be customised by Function #5, or #6.
❖ Touch 5 times:
Switch the Alarm Buzzer
Touch 6 times:
Switch the Alarm Buzzer ON
default setting).
❖ Touch 7 times:
Switch the Alarm Buzzer ON
❖ Touch 8 times:
Report the current fence voltage
for fence diagnostics. Count the number of flashes of POWER LED; this is the first digit.
Count the number of flashes of the FENCE LED; this is the second digit.
The normal voltage range is 2kV to over 8kV
NOTE: If necessary, select Function #2 to put the Energiser into 24-hour Mode.
❖ Touch 9 times:
Like Function #8, this reports the
diagnostics).
❖ Touch 10 times:
Like Function #8, this reports the
❖ More than 10:
Does nothing. Beeps an error.
Rectifying Power Faults
POWER LED Continuously RED:
The internal battery needs more charge. The Energiser will automatically lower its power
consumption to continue operation. It will pulsate less frequently. Check the following:
1. Clean the Solar Panel with water; remove bird droppings and dust.
2. Confirm your solar setup is as described in "Mounting Location".
3. Confirm the panel is facing toward the equator (not east or west), not experiencing
shadowing and can see as much of the sky in all directions as possible.
4. A temporary low power condition may occur during dark cloudy conditions.
POWER LED Flashing RED:
1. In addition to the above points, select Function #1 to test the hardware and Solar
Panel.
2. If your solar location is not ideal, consider setting the Energiser to run in either Night-
Mode or Day-Mode (if acceptable).
POWER LED is OFF:
The Energiser has entered a low-power Sleep Mode to avoid depleting the battery. This
condition might happen if you forgot to switch the Energiser OFF when putting it into
Day Mode & will only operate during the day, starting about 15
OFF. It will not sound if a status error occurs.
and make it active only during daylight hours. (Factory
and active day or night (when operating in 24-hour mode).
in kilovolts (0.5 to 9.9kV). The fence voltage is helpful
lowest fence voltage
highest fence voltage
since midnight. (Useful for
since midnight.
11