Setting The Outgoing Prefix; Setting The Ip Prefix - Renkforce DF-DP-400 Operating Instructions Manual

5. Use the arrow buttons to enter the first digit, and then confirm your entry by pressing the "SET / STORE" button
again.
The second number of the prefix will flash.
Æ
6. Repeat the process to enter the remaining digits of the prefix.
7. Press the "DEL/R" button to exit the settings menu.

10.5 Setting the outgoing prefix

This setting allows you to add a prefix to outgoing calls (e.g. "0"). Follow the steps below to configure the prefix.
1. When the receiver (1) is in place, press the "SET / STORE" button.
The settings menu will be displayed.
Æ
2. Use the arrow buttons to navigate through the submenu until the display shows "SET 3 PCODE".
3. Press the "SET / STORE" button.
"PCODE" will appear on the display, followed by the current prefix.
Æ
If no prefix has been set, "PCODE" will be displayed.
Æ
4. Press the "SET / STORE" button again.
The current prefix setting will flash.
Æ
5. Use the arrow buttons to enter the desired digit, and then confirm your entry by pressing the "SET / STORE"
button again.
6. Press the "DEL/R" button to exit the settings menu.
Note:
– If an outgoing prefix has been set, it will be added automatically if the dialled number consists of more than
5 digits and the first digit differs from the set prefix.
– This applies to callback calls or newly dialled numbers.
– When you re-dial an outgoing call, the outgoing prefix will not be added again.
– When you select an automatic IP prefix, the outgoing prefix will be selected first, followed by the automatic
IP prefix.

10.6 Setting the IP prefix

This setting allows you to set a prefix or configure the required connection information for Voice over Internet Protocol
(VoIP) calls. Proceed as follows:
1. When the receiver (1) is in place, press the "SET / STORE" button.
The settings menu will be displayed.
Æ
2. Use the arrow buttons to navigate through the submenu until the display shows "SET 4 AUTO IP".
3. Press the "SET / STORE" button.
"AUTO IP OFF" will be displayed.
Æ
4. Use the arrow keys until "AUTO IP ON" appears, and then confirm your entry by pressing the "SET / STORE"
button again.
"INPUT CODE" will be displayed.
Æ
5. Enter the service number, card number and, if applicable, the password you received from your provider. Confirm
your entry by pressing the "SET / STORE" button again.
6. Press the "DEL/R" button to exit the settings menu.
20