Advertisement
The Digital Trigger Gauge has two function settings, Peak
and Live. Pressing the MODE button will switch between
these two as desired. The active mode will be displayed
after the first zero on the LCD
Active Mode
MAX, MIN
or AVG
Peak Function:
The peak function will hold the maximum force recorded
during each pull and calculate the maximum, minimum and
average pull weights. These calculations are performed
automatically and will constantly update and remain
in memory until the unit is powered off, or they can be
cleared by holding the DELETE button.
1. Press the MODE button until the word "PEAK" is
displayed
2. In the bottom left corner of the screen the text
"AVG" or "MAX" can be seen. Pressing MODE will
change the display to show the other values, but will
not clear the readings or calculations.
3. With all zeros displayed on the screen, cock the gun
and slowly pull the trigger until it trips.
Placing your trigger finger over the back side of
TIP:
the sensor housing allows you to precisely
control the trigger pull. (PHOTO 4)
(PHOTO 4)
FINGER
4. Pressing ENTER will accept the peak reading and enter
NOTE: Pressing and holding the DELETE button for 2
Number of
recorded pulls
5. After pressing either ENTER or DELETE, the scale will
NOTE: The number of accepted readings is displayed as
Live Function:
The live function provides a real-time reading of the sensor.
It will NOT hold a peak value.
1. Press MODE until the word "LIVE" is displayed after
2. Applying force on the sensor will show the live reading
NOTE: The Trigger Gauge has a maximum reading of
TRIGGER
SENSOR
it into the calculations. Pressing DELETE will void the
reading and prevent it from being used in the calculations.
seconds will clear all calculations.
return to zero and be ready for a new reading. Simply
cock the gun again and repeat to get a new reading.
N=XX in the bottom right corner. We recommend
using at least three to five readings to get an
accurate value.
the first zero on the LCD screen.
at all times and will return to zero when the load is
removed.
12.0lbs (5.45kg). Exceeding this force can cause
permanent damage to the sensor.
Learn more about hunting and shooting we have.
Advertisement
