wheeler 710904 Instructions

Instructions
WARNING: ALWAYS CHECK TO BE SURE GUN IS UNLOADED
BEFORE USING TRIGGER GAUGE.
WARNING: TRIGGER MODIFICATIONS CAN POTENTIALLY
CAUSE THE RIFLE TO MALFUNCTION. TRIGGERS SHOULD
ONLY BE MODIFIED BY COMPETENT GUNSMITHS.
Battery Installation:
®
Your Wheeler Digital Trigger Gauge comes fully assembled
and precisely calibrated from the factory. To use, simply
install 2 AAA batteries by following the steps below.
1. Locate and remove the Phillips head screw
holding the cover on the back side of the unit.
2. Once the cover is removed, place two AAA batteries
into the housing so that the negative side is against
the spring.
3. Replace t he cover and tighten the screw hand tight.
NOTE: Over tightening can damage the device.
The Digital Trigger Gauge will automatically power off after
10 minutes of inactivity.
When the battery power in the device is low, a low battery
icon will display on the upper right corner of the screen.
When this appears, replace the batteries to ensure readings
are accurate.
Usage:
1. Once batteries are installed in the device, press the
button in the center to power it on. The screen
will light up and should display all zeros.
NOTE: Avoid applying any force to the sensor when
turning on the scale
2. Press the UNITS button to change between Pounds/
Ounces and Kilograms as desired.
3. Rotate the arm 180° out of the storage position until
it snaps into the upright position.
Professional Digital
Trigger Gauge
4. The arm may also be twisted 90 degrees to increase
clearance around some gunstocks. (PHOTO1)
NOTE: Always twist the arm back before folding.
Attempting to fold the arm in the twisted
position can permanently damage the product.
(PHOTO2)
NOTE: The Digital Trigger Gauge was designed to
provide the most accurate reading possible
regardless of the position of the arm. By using
a ball joint, errors from pulling at a slight angle
can be minimized.
NOTE: The Digital Trigger Gauge
has a bladed trigger adapter to
allow its use with triggers that
have internal safety blades such
®
as: Glock , Ruger
and other manufacturers.
Adapter sits over the top of the trigger sensor and has a
flatter profile for use on bladed triggers.
Instructions: #1062198 Rev B
Product: #710904
(PHOTO1)
90°
(PHOTO2)
® ®
, Savage
Bladed Trigger