Advertisement
POWE R UP
1. The hands will move to the 4, 8, or 12 o'clock position and stay
there while it searches for the WWVB Atomic Time Signal. Allow
up to 5 nights for the clock to receive this transmission.
2. For the best reception, place the clock on an exterior wall near a
window with the front or back of it facing Fort Collins, CO.
3. Once the Atomic Time Signal is received, the clock will set to
Pacific Time. Firmly press and hold your correct Time Zone Button
until the hands begin to spin. The time will then set correctly.
4. If you live in an area that does not follow Daylight Saving Time,
while the hands are spinning to the correct time, press the
Daylight Saving Time Button once to turn the DST setting to OFF.
Watch the setup video:
bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive the
WWVB reception due to signal strength or interference. In this case,
your clock can be set manually until the Atomic Time Signal can be
received.
MA NUA L LY SE T T IME
1. Remove all batteries from the clock.
2. Press the Manual Set Tab at least 20 times and wait 15 minutes.
3. Insert at least one battery into the Center Battery Compartment.
4. Allow the hands to spin around and stop in either the 4, 8, or 12
o'clock position.
5. Hold the Manual Set Tab until your correct time is achieved.
Note: The Atomic Time Signal will override your manual setting if
the WWVB transmission is received in the future.
Page | 2
1
A
A
3
MT
ET
PT
CT
4
LET'S BE S OCIAL!
Ask questions, watch detailed setup videos, and provide feedback
on our social media outlets!
SPECIFICATIONS
Battery Requirements: 1 AA (IEC LR6) required in movement
(sold separately)
Battery Life: 1 Battery - 12 months
1
Manual Set Tab
Center Battery
2
Time Zone Buttons
3
2
Daylight Saving Time Button
4
(Default is DST ON)
Page | 3
Advertisement
