Rd Pwr Fault Detect; Sata Controller Enable/Disable - Supermicro X6DHT-G User Manual

3rd PWR Supply PWR Fault Detect
(J3P)
The system can notify you in the event of a
power supply failure.
sumes that three power supply units are
installed in the chassis, with one acting as
a backup. If you only have one or two
power supply units installed, you should
disable this (the default setting) with J3P to
prevent false alarms.
SATA Controller Enable
JPS1 enables or disables the AIC 8140
Marvell SATA
board. See the table on the right for jumper
settings. The default setting is enabled.
LAN1
LAN2
This feature as-
Controller on the mother-
JPW1
2-25
3rd PWR Supply PWR
Jumper Settings (J3P)
Jumper
Position
Open
Closed
Jumper
Position
Pins 1-2
Pins 2-3
SATA Controller
Enable
12V 8-pin
SMBus
P W R
P W R
WOL
Chapter 2: Installation
Fault Detect
Definition
Disabled
Enabled
SATA Controller
Enable/Disable
Jumper Settings
(JPS1)
Definition
Enabled
Disabled
3 r d P W R F a u l t
Detect
PSF
OH
LED
JPS1
JWOR
JL1