Table of Contents
Advertisement
EN 20
4.
QM15.2E LA
4.3.2
Keyboard Control unit
1. Unplug the connector [2] from the keyboard control panel.
2. Remove the fixation screws [1] that secure the keyboard
4.3.3
Small Signal Board (SSB)
Refer to
Figure 4-19
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB[1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] .
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-19
for details.
2015-Sep-30
Mechanical Instructions
Figure 4-18 Keyboard removal
4.3.4
back to
div.table
3. Gently take the keyboard out. Refer to
details.
When defective, replace the whole unit.
3
2
1
2
3
Figure 4-19 SSB removal
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
Figure 4-18
for
2
1
1
19880_107.eps
3
3
19880_108.eps
Advertisement
Table of Contents
