Table of Contents
Advertisement
3170 PRIVACY SCREEN
LEG INSTALLATION
1. 1. Using a Phillips Screwdriver, install (2) Screen Leg Reinforcement Tubes (#5) between Leg Frame
Assemblies (#3) using 4-Phillips Head Screws (5A), one on each end, through (#3) into (#5). Leave screws
on one Leg Frame Assemblies (#3) loose to allow assembly to be inserted into Wing/Mid Frame Assembly
(#1A).
2. Insert both Leg Frame Assemblies (#3) into the bottom of the Wing/Mid Frame Assembly (#1A). Line up
the holes in (#3) w/ the holes in (#1A).
3. Using the Allen Wrench provided, screw in 1-Button Socket Screw (3D), per leg, through (#1A) and into
(#3). Tighten 2-Phillips Head Screws (5A) that were left loose in step 2.
PANEL REPLACEMENT
4. To replace Vinyl Panels (#4), hold the screen by the top Screen Rod (#2A).
5. Next, using the Allen Wrench provided, push in on the small hole just below the Snap Button (#2B).
6. Re-install (#2A) by repeating the above procedure, then release (#2B) when (#2A) is in place.
IMPORTANT:
•
Wrinkles in Vinyl – Storage and/or shipping can cause wrinkles in the vinyl screen. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70+ degrees) to allow for vinyl to return to
original appearance.
Page 8 of 13
manual
Document No.: 006005 - Revision: A
(SEE PHOTOS ON NEXT PAGE)
(SEE PHOTOS ON NEXT PAGE)
Advertisement
Table of Contents
