3130 Three Panel Screen; Prepare Leg Assemblies; Leg Installation - Champion 3130 Owner's Operating And Maintenance Manual

3130 THREE PANEL SCREEN

PREPARE LEG ASSEMBLIES

1. If not already installed, insert the caster inserts into open ends of screen legs. (This is done for crutch tip or
caster installation.)
2. You must choose either casters or crutch tips for your screen – both are provided to you. Casters must be
inserted into the caster inserts. Crutch tips must be installed over the ends of the legs.

LEG INSTALLATION

3. Install legs on mainframe using (4) ¼" x 1-1/2" Phillips head screws and locknuts.
NOTE: Make sure the legs are installed so that the bends of the legs face the outside of the frame. This
is necessary to provide the maximum footprint.
4. Use your Phillips head screwdriver and 7/16" wrench to tighten.
5. Bolts must fit snugly into holes for secure leg mount.
6. Verify that your screen is level and straight. If necessary the legs can be slightly bent so that all legs touch the
floor and screen stands straight.
WARNING
IMPORTANT:
PANEL REPLACEMENT
1. To replace Vinyl Panels, grasp Screen Rod; Screen Rod is spring-loaded and can be moved toward end
with spring. Push & pull the Screen Rod to determine which way will compress the spring and allow
removal of the Screen Rod.
2. Re-install the Screen Rod by reversing the above procedure.
3. Periodically check all fasteners for tightness. To clean Vinyl Panels use only mild liquid soap and
water.
Wrinkles in Vinyl – Storage and shipping causes wrinkles of the vinyl of your screen; This is normal.
•
Please allow 1 – 2 weeks at room temperature (approx. 70+ degrees) to allow for vinyl to return to
original appearance.
Page 6 of 13
manual
Document No.: 006005 - Revision: A
Periodically recheck tightness of all fasteners and NEVER stand on or hang from the
screen.