BYD SEAL Owner's Manual page 67

Memory setting method
Memory setting in OK mode
●
Press and release the "SET" button
●
on the seat memory switch, and
press either "1" or "2". Then the
positions of the seats and side
mirrors will be remembered, and the
memory setting finishes.
Press and release the "SET" button
●
on the seat memory switch, and
press either "1" or "2" within 3
seconds. Then the positions of
the seats and side mirrors will
be remembered, and the memory
setting finishes.
If the position button on the memory
switch has already been set, the position
set will be overwritten.
Memory wake-up function
Memory wake-up function in OK mode
With the gearshift lever in the "P"
●
position, the driver's seat memory
system will perform memory wake-up
operation when the memory system
switch is pressed if the following
conditions are met:
The vehicle is not in anti-theft mode.
●
No speed.
●
Memory switch signals are valid.
●
No actions are performed by the
●
seats and side mirrors.
Heating and Ventilation Systems*
To enable or disable the heating
●
& ventilation function, go to
Infotainment touchscreen
→ Seat Operation.
Tap "Drop-down" on the home page
●
of the infotainment system to operate
the seat heating and ventilation setting
buttons.
66
Heating system adjustment
Seat heating: Control the operation
●
mode of the heating pad by using
the seat heating switch. The heating
function has two modes.
●
●
●
Ventilation system adjustment
Seats Ventilation: Control the
●
operation mode of the ventilation fan
by using the seat ventilation switch.
Seat ventilation has two modes.
●
●
●
Ventilation and heating functions
cannot be turned on at the same time.
Press the ventilation switch to make
●
the ventilator work; if the heating
switch is then pressed, the ventilator
will stop and the heater will start to
work.
Press the heating switch to make the
→ A/C
●
heater work; if the ventilation switch is
then pressed, the heater will stop and
the ventilator will start to work.
After each power-on, the driver's
seat remembers the last mode,
and the initial heating state of the
passenger's seat is Off.
Press the switch to select the
operation mode of the seat heater in
the 1st gear or 2nd gear.
Press the OFF gear to deactivate the
heating function.
After each power-on, the driver's
seat remembers the last mode, and
the initial ventilation state of the
passenger's seat is Off.
Press the switch to select the
operation mode of the seat
ventilation in the 1st gear or 2nd
gear.
Press the OFF gear to deactivate the
ventilation function.