Table of Contents
Advertisement
38 electrolux
Problem
It is too warm in the
refrigerator.
It is too warm in the
freezer.
Water flows at the
back plate of the
refrigerator.
Water flows into
the chamber.
Water flows onto
the floor.
There
are
too
much frost and ice.
GB
Possible cause
Thermostatic control can be set
wrongly.
If products are not cold enough
or placed wrongly.
The door does not close tightly
or it is not shut properly.
Thermostatic control can be set
wrongly.
The door does not close tightly
or it is not shut properly.
Products in big quantity to be
frozen were put in.
Products to be frozen are placed
too closely to each other.
It is normal. During automatic
defrosting frost melts on the
back plate.
The outlet of the chamber can
be clogged up.
Products placed in can prevent
water from flowing into the
collector.
The melting water outlet flows
not into the evaporative tray
above the compressor.
Products are not wrapped
properly.
Doors are not shut properly or
do not close tightly.
The thermostatic control can be
set wrongly.
Solution
Set the thermostat knob to
higher position.
Place the products to the
appropriate place.
Check if the door closes well
and the gasket is unhurt and
clean.
Set the thermostat knob to
higher position.
Check if the door closes well
and the gasket is unhurt and
clean.
Wait some hours and then
check the temperature again.
Place the products in a way
so that cold air could circulate
among them.
Clean the outlet.
Replace the products so that
they can not touch the back
plate directly.
Put the melting water outlet to
the evaporative tray.
Wrap the products better.
Check if the doors close well
and the gaskets are unhurt
and clean.
Set the thermostat knob to a
position that gives higher
temperature.
Advertisement
Table of Contents
