Storage; Storage Safety; Storing The Machine - Toro SnowMaster 724 ZXR Operator's Manual

Storage

Storage Safety

•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Fuel fumes are highly flammable, explosive, and
dangerous if inhaled. If you store the product in an
area with an open flame, the fuel fumes may ignite
and cause an explosion.
•
Do not store the machine in a house (living
area), basement, or any other area where ignition
sources may be present, such as hot water and
space heaters, clothes dryers, furnaces, and other
appliances.
•
Do not tip the machine either forward or backward
with fuel in the fuel tank; otherwise, fuel may leak
out of the machine.
•
Do not store the machine with its handle tipped
down onto the ground; otherwise, oil may leak into
the engine cylinder and onto the ground, and the
engine may not start.

Storing the Machine

WARNING
Fuel fumes are highly flammable, explosive,
and dangerous if inhaled. If you store the
product in an area with an open flame, the fuel
fumes may ignite and cause an explosion.
• Do not store the machine in a house (living
area), basement, or any other area where
ignition sources may be present, such
as hot water and space heaters, clothes
dryers, furnaces, and other appliances.
• Do not tip the machine either forward
or backward with fuel in the fuel tank;
otherwise, fuel may leak out of the
machine.
• Do not store the machine with its handle
tipped down onto the ground; otherwise,
oil leaks into the engine cylinder and onto
the ground, and the engine does not start
or run.
1. On the last refueling of the season, add fuel
stabilizer to fresh fuel as directed by the
fuel-stabilizer manufacturer.
Important:
than that suggested by the fuel-stabilizer
manufacturer.
2. Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3. Shut off the engine, allow it to cool, and siphon
the fuel tank or run the engine until it shuts off.
4. Start the engine and run it until it shuts off.
5. Choke or prime the engine, start it a third time,
and run the engine until it does not start.
6. Drain the fuel in the carburetor through the
carburetor-drain bolt into an approved gasoline
container.
7. Dispose of unused fuel properly. Recycle it
according to local codes, or use it in your
automobile.
8. While the engine is still warm, change the engine
oil. Refer to Changing the Engine Oil (page
9. Remove the spark plug.
10. Squirt 10 ml (2 tsp) of oil into the spark-plug hole.
11. Install the spark plug by hand and then torque it
to 27 to 30 N∙m (20 to 22 ft-lb).
12. With the ignition key removed, pull the
recoil-start handle slowly to distribute the oil on
the inside of the cylinder.
13. Clean the machine.
14. Touch up chipped surfaces with paint available
from an Authorized Service Dealer. Sand
affected areas before painting, and use a rust
preventative to prevent the metal parts from
rusting.
15. Tighten any loose fasteners. Repair or replace
any damaged parts.
16. Cover the machine and store it in a clean, dry
place out of the reach of children. Allow the
engine to cool before storing the machine in any
enclosure.
16
Do not store fuel longer
13).