Honda CB125F 2017 Owner's Manual page 94

Tyre Puncture Removing Wheels
u
Installation
To install the rear wheel, reverse the
1.
removal procedure.
Tighten the rear axle nut.
2.
Torque: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Tighten the brake stopper arm nut.
3.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Adjust the rear brake pedal freeplay.
4.
P. 65
2
Adjust the drive chain slack.
5.
After installing the wheel, apply the brake
6.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
90
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin
with a new one.
P. 71
2