Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
8. Slide reflector plate onto reflector panels.
Insert one
screw
M6 X 10 (II). Slide one washer Φ 6
over threaded end of
cap nut (JJ) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the screws in the rolled edge.
9. Support heater. Slide three washers washer Φ8 (GG)
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers Φ8 on spacers and
securely tighten wing nuts (KK) but do not overtighten.
Hardware Used
Washer Φ8
GG
KK
Wing nut
screw
M6 X 10 (II) and screw on
x 6
x 3
8
JJ
HH
II
9
KK
GG
9
TT
GG
FF
Advertisement
Table of Contents
