Cleaning The Radiator - Toro Groundsmaster 360 Operator's Manual

3. Install the expansion-tank cap.
1. Expansion tank

Cleaning the Radiator

Service Interval: Before each use or daily Clean the radiator
more frequently in extremely dusty and
dirty conditions.
Keep the radiator clean to prevent the engine from
overheating.
Note: If the attachment or engine shuts off due to
overheating, first check the radiator for an excessive buildup
of debris.
1. Open the hood and secure the prop rod.
2. Loosen the flange nut securing the clean-out cover to
the underside of the rear frame
cover to the side to expose the clean-out hole in the
frame.
1. Clean-out cover
3. Working from the fan side of the radiator, blow out
debris with low-pressure (50 psi) compressed air (do
Figure 45
(Figure 46). Rotate the
Figure 46
not use water). Repeat this step from the front of the
radiator, again from the fan side.
4. After you have thoroughly cleaned the radiator, remove
any debris from the channel at the radiator base and
around the frame.
5. Clean the engine compartment and the brake linkage.
6. Close the clean-out cover and secure the flange nut.
7. Close the hood.
g014268
G014515
g014515
46