Figure 81
1. 76 mm (3 inches)
2. Rear blade tip
3. Front blade tip
8.
Fine-tune the adjustment nut on the front deck
lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn it
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cutting height,
you can use the single-point adjustment to gain
more adjustment.
g009997
4. 76 mm (3 inches)
5. Level surface
(Figure
82).
1. Deck adjustment
2. Jam nut
9.
Measure the rear blade tip height. Fine-tune the
rear adjusters as required; use the single-point
adjustment to gain more adjustment.
The rear tips of the side blades should measure
76 mm (3 inches).
10.
Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck-lift arm
assemblies.
11.
If the 4 deck adjusters do not have enough
adjustment to achieve the accurate height of
cut with the desired rake, you can adjust the
single-point system
61
Figure 82
3. Adjustment nut
(Figure
83).
g231991