Advertisement
INSTALLATION
Mounting
● Siren amplifier
1. Select a location that is not exposed directly to weather elements, such as the driver compartment
firewall, below the seat, or in the trunk; avoid any interference of air bag deployment.
2. Using the siren amplifier as a template, mark four mounting holes to be drilled.
3. Drill four mounting holes for sheet metal screw.
4. Install the siren amplifier with provided sheet metal screws and tooth lock washers.
● Controller clip
1. Select a location where is convenient to the operator; avoid any interference of air bag deployment.
2. Using the mounting clip as a template, mark the two holes to be drilled.
3. Drill two mounting holes for sheet metal screws.
4. Install the microphone clip with provided sheet metal screws.
PINCH HAZARD - Steel, iron and/or other ferrous objects may be attracted suddenly and
WARNING
forcefully to the magnets, creating the risk of pinch-type injuries. Keep all mild steel and iron
tools and equipment well away from the magnets at all times.
IMPORTANT! - Be certain to keep the controller away from the mounting location until you've
cleaned up any metal shavings or other debris.
Top view
136.2mm (5.36")
126mm (4.96")
Rear view
CONTLR
0. IGN
1. SW1
2. SW2
3. SW3
4. SW4
4.5mm
- 9 -
113.42mm (4.47")
I / O
5. HORN IN
6. RAD IN +
7. RAD IN –
8. SPK +
9. SPK -
Advertisement
