Whirlpool ADG 3550 Quick Reference Manual

39696039GB.fm Page 1 Tuesday, February 28, 2006 2:54 PM
ADG 3550
On/Off button
Press the ON button to switch on the dishwasher.
The indicator lamp of the last programme selected
lights up; at the end of the cycle an acoustic signal
sounds.
Programme selection button
Press the button to select a programme.
The corresponding indicator lamp lights up.
Indicators
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Add rinse aid
Extra functions (*)
Half-load wash (top basket)
selection key
Press the button to select the option; the
corresponding indicator lights up. Press the
button again to deactivate the option; the
corresponding indicator goes off.
"Delayed start" button
The wash cycle can be programmed to
start after 3-6-9 hours. Press the button in
order to select the delayed start; the
corresponding warning light will turn on.
After a bried pre-washing of the
kitchenware, the washing with the
previously set up setting can be started. In
order to exit from the selection mode and
start the wash without a delayed start,
press the button until warning lights 3-6-9
are turned off.
Programmes
Pre-rinse
Rapid 30 min
1)
Eco
(**)
Sanirinse
Intensive
(*) Extra functions available in all programmes, except prewash.
(**) The program is characterized by a final anti-bacterial rinse in
order to guarantee an additional reduction in bacteria. If the
temperature does not remain constant during the anti-
bacterial rinse (for e.g. due to opening of the machine's door
or energy loss), the program warning lights will flash,
specifying that the anti-bacterial action is not guaranteed.
Whirlpool is a registered trademark of Whirlpool USA
Black process 45.0° 150.0 LPI
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme chart
Loading instructions
cold
Crockery to be washed later.
45°C
Lightly soiled crockery, with no dried-on food.
55°C
Normally soiled crockery.
Normally or very dirty, with additional anti-bacterial
65°C
action.
Recommended programme for heavily soiled
70°C
crockery, especially suitable for pans and saucepans.
1)
2)
3)
Additional options in case of failure
Indicators
Water stop device activated
Switch off the dishwasher and contact the
After-sales Service.
The dishwasher over fills with water
Reset and start the programme again from the
beginning. If the problem persists, contact the
After-Sales Service.
The water heating system is not working
Reset and start the programme again from the
beginning. If the problem persists, contact the
After-Sales Service.
Water heating anomaly
Reset and start the programme again from the
beginning. If the problem persists, contact the
After-Sales Service.
The dishwasher does not fill with water
Check the water supply and filters, and make sure
that there are no kinks in the water inlet hose.
Open and close the door in order to continue.
The dishwasher does not drain
Make sure that the filter unit and drain hose are not
clogged and if necessary clean them.
Flow meter anomaly (if provided)
Reset and start the programme again from the
beginning. If the problem persists, contact the
After-Sales Service.
Alternate washing system anomaly
(if provided)
Reset and start the programme again from the
beginning. If the problem persists, contact the
After-Sales Service.
Fault in water load system
Switch off the dishwasher and contact the After-
sales Service.
2)
Detergent
A B
- -
X -
X -
X -
X X
Reference programme for energy label in compliance with
EN 50242 regulations;
Refer to "User instructions";
Program data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different
loads, water temperatures - above or below 15° C - as well as
water hardness and power supply voltage, etc.
5019 396 96039
(We reserve the right to make technical modifications)
GB
Off
Blinking
On
3)
Consumption
Litres kWh Minutes
6.0 0.03 16
13.0 1.15 45
15.0 1.08 180
17.0 1.37 100
20.0 1.75 110