Advertisement
1. Introduction
1.1
Safety
When not properly used the Meat Grinder can be potentially DANGEROUS.
Servicing, cleaning or any other operation shall be made by trained people.
The following instructions must be observed in order to avoid accidents:
1.1.1 Always unplug the machine when cleaning, servicing or when any other operation
is needed.
1.1.2 Never use tools that do not belong to the machine during operation.
1.1.3 Before switching the machine on check if the Head Nº01 (Pic.01) is firm in its
position, if all its internal components are assembled as well as if the Pan Nº04 (Pic.01)
is mounted.
1.1.4 Never spray water or other liquid substances directly at motor, power switch or any
other electrical components.
1.1.5 Never use loosen clothes specially shirts with loosen sleeves during operation.
1.1.6 Never put your fingers or any other object but the Stomper Nº05 (Pic.01) inside
feeding throat.
1.1.7 Keep hands off turning parts.
1.1.8 Never switch the machine on with wet clothes or wet shoes.
1.1.9 Before using the machine make sure it is properly grounded.
Your equipment is also protected against any eventual failure. Operator and
motor's integrity is maintained under this adverse condition. This protection is possible
by means of a thermal overload switch. In case your equipment suddenly stops wait for
a few minutes and press thermal overload switch button located at rear of machine.
This equipment shall not be used by persons (including children) having reduced
mental or physical capabilities, or having faulty experience or knowledge, unless
they have been previously supervised or instructed by a person responsible for
the equipment safety, about how to use it.
If the cord is not in good conditions to be used, it has to be changed by the
manufacturer or an Authorized Technical Assistant.
IMPORTANT
IMPORTANT
02
Advertisement
Chapters
