Preparing The Machine For First Use; Before Starting; To Start - NU CRTN836 Operator's Manual

2.2 Preparing the Machine for First Use

2.2.1 Make sure all loose packaging materials have been removed from the
Machine.
2.2.2 Check the machine and its components for damage. If there is visible
damage, do not operate the machine! Contact our dealer immediately for assistance.
2.2.3 Take inventory of all items included with the machine and verify that
all loose components and fasteners are accounted for.
2.2.4 Attach component parts not already attached.
2.2.5 Add fluids as needed and applicable, including fuel, engine oil, and
battery acid.
2.2.6 Move the machine to its operating location.

2.3 Before Starting

New Ride-on Power Trowel has been assembled and tested at the factory. However, before
starting the trowel, the following items should be checked:
Fuel level

Water level

Oil level in the engine

Condition of the air filter

Condition of trowel arms and blades

Grease the trowel arms daily.

NOTICE: Check the oil level in the engine and gearbox. Engine and trowel warranties are VOID if
this unit is run without oil.

2.4 To Start

Before starting the operator must know the location and function of all controls.
1. Adjust the chair to the comfortable position for the operator.
2. Push down on the left safety stop pedal, turn the engine keyswitch, and hold it until the engine
starts.
NOTICE: If the engine is cold, pull out the choke control knob fully. The choke may need to be
opened even when starting a warm engine.
NOTICE: Cranking the engine for more than 5 seconds can cause starter damager. If the
engine fails to start, release the keyswitch and wait 10 seconds before operating the starter
again.
3. Allow the engine to warm up before operating the trowel.
4. Push down on the throttle foot pedal to start the trowel
12