Primo Water PRSF-80507 Use Instruction page 20

- " " of the remote control: to turn the fan on or turn it off in standby mode
- "SPEED" of the remote control: the symbol corresponding to the selected speed
will light up: ( = min;
- Mode: the three modes are selected by pressing the "MODE": button:
1. Normal: constant ventilation
2. Silent: constant and silent ventilation (symbol "zzz")
3. Natural: intermittent ventilation (symbol " "), as shown in the diagrams shown here.

- Timer: sets the operating time at which the unit shuts down. Press the "TIMER"
button repeatedly: each press changes the time in 0.5 hour intervals (from 1⁄2 hour
to 7 .5 hours), and the selected duration will be shown on the control panel. To
deactivate the timer, press the button until the timer turns off.

- Swing (right-left): press the "SWING" button, turn it on and or turn it off to press
again
Fan Tilt
Set fan tilt angle by gently pushing upwards or downwards.
Ensure that fan is switched off before adjustment.
CLEANING

Switch off and unplug from the power supply before assembling or disassembling and
cleaning.

Keep the air vents at the rear of the main body free from dust or fluff– use a vacuum cleaner
to remove these when necessary. Do not probe any opening to remove fluff.

Fan component parts should be cleaned using mild soap and a damp cloth or sponge. Do
not allow any water or other liquid to enter the motor housing.

Thoroughly remove soap film with clean water.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they may damage
the surface finish of the fan components.
= med; = max).
19