Advertisement
How to use it
•
Open the battery case at the bottom of the outer bowl. Insert four AA batteries
and close the case.
•
Place the inner pot into the outer bowl.
•
Place the ignition plate in the base of the inner pot.
You then have two options for lighting the charcoal box. Choose one of the below
options:
Option 1. Light the charcoal box using cube firelighters
•
Put the ignition plate into the inner bowl and the charcoal box on the ignition
plate.
•
Place 3 to 4 cube firelighters in the charcoal box then fill it with heat beads.
•
Light the cubes using a match or automatic firelighter and wait a few seconds
before covering the charcoal box with thelid.
• Turn the turbo fan knob clockwise to the maximum position (the ventilation
must be on so that the flame is not extinguished)
Option 2. Lighting the charcoal box using lighter
•
Put the ignition plate into the inner bowl.
•
Apply a circular layer of lighter gel on the ignition plate, approximately 10mm
wide.
•
Turn the turbo fan knob clockwise to the maximum position (the ventilation
must be on so that the flame is not extinguished)
•
Light the gel until it burns, being careful not to touch the flame.
•
Place the charcoal box on the ignition plate, taking care to place it evenly.
Having implemented the steps above for your chosen lighting method,
continue set up with the following steps:
•
Put the lid on the charcoal box.
•
Put the grill rack on top of the inner pot and pull down the latch(if available) to
lock the device.
•
After approximately 10 minutes, the grill should be ready for use.
Note: The fan must stay on at all times while you are
.
gel
.
cooking.
OWNER'S MANUAL
Advertisement
