Operation; Fitting And Filling The Blender - Silvercrest 339195 1910 Operating Instructions Manual

Operation

WARNING!
The motor switches off automatically as soon as the blender 3 is removed
►
from the motor block 6 or the lid 2 is opened. In such cases it may be
easy to forget that the machine is still switched on. The motor will then start
unexpectedly as soon as the blender attachment 3 is fitted or the lid 2 is
closed again:
Therefore:
–
Do not insert the power plug into the wall socket until the blender 3 is
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Switch the appliance off first, pull the plug out and wait until the motor has
come to a standstill before removing the blender 3 or opening the lid 2.
Fitting and filling the blender
1) Remove the blender 3 from the motor block 6 in a vertical, upward motion.
2) Remove the lid 2 by rotating it anticlockwise towards position
until you can pull it upwards.
3) Fill the blender 3.
4) Press the lid 2 firmly down onto the blender 3. Close the lid 2 by turning
it clockwise to position
the pouring spout on the blender 3 is closed. The motor cannot start until
the lid 2 is fitted flush.
Fig. 1
5) Press the measuring cap 1 into the lid as far as the stop.
6) Place the completely filled and closed blender 3 with the handle to the
right on the motor block 6. Make sure that the arrow
points to the
back and forth if it does not immediately sit properly. The motor cannot start
until the blender 3 is fitted flush to the motor unit.
SSMC 600 B1
until it audibly engages (see Fig. 2). Ensure that
Fig. 2
arrow on the motor block 6. Turn the blender 3 slightly
(see Fig 1)
on the blender 3
GB │ IE │
25 ■