Makita XMU05 Instruction Manual page 15

4. Apply a small amount of grease to the periphery of
the crank. Attach the crank to the pins with its small and
large rounds facing down.
► 1 . Crank
5. Slide the shear blades so that the hole on the
guide plate is positioned at the center of the rings of
blades.
► 1 . Guide plate
6. Turn the shear blades upside down and install
them so that the pin on the tool fits in the hole on the
shear blades. Insert the claw of the guide plate into the
groove on the tool. Make sure that the shear blades are
fixed securely in place.
► 1 . Claw 2. Guide plate
NOTE: Sliding the blade cover forward slightly makes
it easier to install the shear blades.
1
1
7. Tighten the two screws firmly with a screwdriver.
► 1 . Screws
8. Place the undercover so that
cover is aligned with
1
► 1 . Lock lever 2. Undercover
9.
While pressing the undercover, turn the under-
cover clockwise until
with on the lock lever.
2
► 1 . Undercover
15 ENGLISH
1
on the under-
on the lock lever.
on the undercover is aligned
1
2
1