Table of Contents
Advertisement
Maintenance
Install the new reflector
11. Continue with mounting either
the glass reflector:
or the aluminium reflector:
Continue for both versions with glass reflector or aluminium reflector with
12. Take the lamp carrier (13) with its lamp holder (15) and anti-dazzle screen (16).
13. Push the cable (14) through the hole in the centre base. Be careful not to damage the
cable or scratch the reflector.
14. Screw on the lamp carrier (13) to the centre base using the 3 screws (11).
15. Reconnect the open wires (14) and the connector which were cut apart before. Be
sure that this electrical connection is done in a proper way following acknowledged
rules of technology.
16. Reconnect the external power cable and the internal wiring.
17. Reassemble the rear panel (8) with the inside chassis.
18. Reinstall the halogen lamp (5).
19. Push the inner chassis with the rear panel (8) mounted into the searchlight housing.
20. Screw (9) on the rear panel (8) to the housing.
The reflector is exchanged.
Operating Instructions SW450/A-2000
Attention!
Only use degassed silicone gel for this step. Vapour from silicone which has
not been degassed will collect on the lamp and destroy it.
a. Glue the new mirror onto the retaining ring using silicone gel.
Allow to dry for one day!
b. Place the mirror onto the unit and re-fasten it with the four screws 8 and
the leaf springs (18).
a. Place the new reflector on the centre base (19).
b. Screw on the reflector with the four screws (10).
Ver 2.0 -07 /2023
Article no: 30078456001
34
Advertisement
Table of Contents
