Kirby G5 Service Manual page 5

SECTION 2
THE SERVICE CENTER/DEPARTMENT OPERATION
TOOLS AND METERS
Tools required include:
- Screwdrivers - Flat - Assorted Sizes
- Screwdriver - Phillips - Assorted Sizes
Pliers - Assorted
-
- Impact Screwdriver
-
Bench Vice
-
File - Round Rattail
-
File - 1/4" pillar - 6" long
-
Tap Wrench
- Threading Tap 6
-
Threading Tap 8 x 3 2
- Threading Tap 10
-
Threading Tap 10
In addition. certain special tools and supplies available from the factory are:
Tools:
-
Fan Locking Pin T104 S
-
Torque Screwdriver Kit Tl67
-
No. 0 200 Snap Ring Expander Pliers Tl 54
-
No. 0300 Snap Ring Compressor Pliers Tl 55
-
Open End Wrench
- Bearing/Slide Centering Gage TT - 150
-
Rear Bearing Puller - Universal T l 27 A
-
TX20 Torx Bit 1" T l 57
Torx Bit Set - T166S (TXl0 l", TX15 l ", and TX20 1 15/16")
-
Supplie � :
GS Touch-up Paint 309 297
Sealant, Silicone, Tl 17 Tube and Tl 18 Cartridge
-
- Bearing Plate Eyelet Grease Tl59S
- Ratchet Lock and Ratchet Pedal Grease Tl 59S
-
Rear Axle Grease T160S
-
Gasket Lubricant 289094S
Meters required for analysis and electrical safety testing are:
-
Watt meter - with range to 5000 watts
-
Ohmmeter or Battery - Powered Test Light
-
Ohmmeter - 0.001 Ohm accuracy
- High Voltage Insulation Tester
These meters should be available through electrical equipment or motor service and sup­
ply companies in your area. Follow the manufacturer's operating instructions \vhen using
these meters. Practice safe working habits at all times.
-120
-
8" long
32
x
24
x
32
x
1 1/32" Tl56
- range 500/2500 V AC
8
VT