Product Overview - Toro Power Max 824 OAE Operator's Manual

Figure 10
The machine should move rearward. If the
machine does not move or moves forward,
complete the following:
A. Release the traction lever and shut off the
engine.
B. Disconnect the trunnion from the
speed-selector lever.
C. Turn the trunnion downward (clockwise) on
the speed-control rod.
D. Connect the trunnion to the speed-selector
lever.
4. Release the traction lever.
5. Move the speed selector to Position 1; refer to
Operating the Speed Selector (page
6. Squeeze the left (traction) lever to the handgrip
(Figure 10).
The machine should move forward. If the
machine does not move or moves rearward,
complete the following:
A. Release the traction lever and shut off the
engine.
B. Disconnect the trunnion from the
speed-selector lever.
C. Turn the trunnion upward (counterclockwise)
on the speed-control rod.
D. Connect the trunnion to the speed-selector
lever.
7. If you made any adjustments, repeat this
procedure until no adjustments are required.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 21)
to an Authorized Service Dealer for service.
16).
Checking and Adjusting
or take the machine

Product Overview

g001011
1. Handgrip (2)
2. Auger/impeller lever
3. Speed-selector lever
4. Quick Stick®
discharge-chute control
5. Traction lever
6. Fuel-tank cap
7. Oil-fill tube/dipstick
8. Chute deflector
11
Figure 11
9. Discharge chute
10. Scraper
11. Auger
12. Skid (2)
13. Electric-start button
14. Electric-start plug-in
15. Snow-cleanout tool
16. Headlight (Model 37799
only)
g254701