Table of Contents
Advertisement
Available languages
Available languages
Install Washing Machine
Install Washing Machine
Remove transit bolts
Before using this washing machine,transit bolts must be removed from
the backside of this machine.Please take the following steps to remove
the bolts:
1.Loosen the four transit
bolts with a spanner
Keep the transit bolts properly for futher use.
Level the washing machine
Install or place the washing machine under the environmental temperature of not
less than 0℃but not outdoors, for it may damage the programming controller.
1.Check whether the foot is under factory state; if not, restore the foot to factory state: ensure
the rubber gasket close to the bottom of the drum body and the lock nut close to the rubber
gasket.
2.Hold the diagonal angles of the top cover of the washing machine with two hands, and then
press straightly downward and shake, to check if the supporting feet are close to the ground.
3.Level the washing machine only by left- or right- rotating it to proper position, until the
machine stop shaking and stay close to the ground.
01
01 Check whether the supporting feet are under factory state; if not, restore it to factory state.
02
Check whether the washing machine shakes.
03
Left- or right- rotate the machine to proper position, until the machine stop shaking and stay close to
the ground.
CAUTION
1.The machine must be perfectly leveled and stabilized when the four
supporting feet are close to the ground. Lower the feet as much as possible
on the basis that the machine is leveled.
2.Improper leveling adjustment may cause loud noise, machine vibrating,
machine displacement and other abnormal phenomena.
3.Air-vent is designed on the bottom of the machine (prevent blockage). Install
the washing machine on solid, smooth and skid-proof ground. Do not place
the washing machine on soft blanket or wooden floor, or various desktops
and stands, in case of unnecessary injury.
2.Take each bolt head and pull it
through the wide part of the hole.
Repeat for each bolt.
02
5
5
3.Fill the holes with the
supplied plastic covers.
or
03
Advertisement
Table of Contents
